home
StrataCafe Forums
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 StrataCafe
 Strata Design 3D CX
 how to do a double helix?
 New Topic  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

armano
Infrequent Poster

Germany
42 Posts

Posted - 11/16/2007 :  09:49:51  Show Profile
hi folks its me again,

is it possible to do it in Strata?

Brian Lawson
A Fountain of Information

USA
5217 Posts

Posted - 11/16/2007 :  10:17:50  Show Profile  Visit Brian Lawson's Homepage  Send Brian Lawson an AOL message
It is but you have to take a round about route to get there. Check out this topic on making a corkscrew path. You'll use the same technique for this.

Brian Lawson
Strata Technical Support
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Topic Locked
 Printer Friendly
Jump To:
StrataCafe Forums © 2009 StrataCafe Go To Top Of Page
Snitz Forums 2000